|
|
Final Construction
TV is in, and it's a near-perfect fit, about 1/2 inch on each side, and it rests right against the back panel, so I won't have to mount the TV permanently.
.JPG)
I printed this marquee on my inkjet, you can see the left seam a bit in the pic below, overall, I thought it came out damn nice. Sandwiched it in plexi, and mounted it using wall corner drop tile ceiling supports spray painted black and screwed in.
08/11/04
Got the bezel on, and cut the top part some so it would fit. I need to paint the TV casing on the top black since the marquee didn't quite fit. I also need to velcro it to the sides so it stays in place better (You can see the TV on the right side in the pic below, the velco will fix that nicely) I mounted the Light fixture behind the marquee as well, $6.76 at walmart, easy mount, I have to setup some poster board inside to block the light from getting out past the speakers, and out the back of the cab, etc...
08/11/04
.JPG)
The only pic I could get of the CRAMPED inside of the cab. The subwoofer on the left, Smartstrip in the middle, computer case on the right. The computer case I had BARELY fit. I had to take out the DVD drive because it couldn't eject. The drive is sitting on top of the case now.
08/11/04
.JPG)